Users Guide
mep cross-check enable
Enable cross-checking.
Syntax
mep cross-check enable {port | vlan-id}
Parameters
port Down service with no VLAN association.
vlan-id Enter the VLAN to apply the cross-check.
Defaults none
Command Modes ECFM DOMAIN
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced on the S-Series.
mep cross-check start-delay
Congure the amount of time the system waits for a remote MEP to come up before the cross-check operation is started.
Syntax
mep cross-check start-delay number
Parameters
start-delay number Enter a start-delay in seconds. The range is from 3 to 100 seconds.
Defaults 3 ccms
Command Modes ETHERNET CFM
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
8.3.19.0 Introduced on the S4820T.
802.1ag
165