Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S3048-ON

1591

Command History

This guide is platform-specic. For command information about other platforms, see the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.5(0.1) Introduced on the Z9500.

9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-

Mux (PMUX) mode only.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.8.0 Introduced on the S4810.

Usage Information After you congure a VLT domain on each peer switch and connect (cable) the two VLT peers on each side

of the VLT interconnect, the system elects a primary and secondary VLT peer device. To congure the

primary and secondary roles before the election process, use the primary-priority command. Enter a

lower value on the primary peer and a higher value on the secondary peer.

If the primary peer fails, the secondary peer (with the higher priority) takes the primary role. If the primary

peer (with the lower priority) later comes back online, it is assigned the secondary role (there is no

preemption).

show vlt brief

Displays summarized status information about VLT domains congured on the switch.

Syntax