Users Guide

Version Description
9.5(0.1) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
9.2(0.2) Added multicast and ndp parameters.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
Example
VLT ARP Statistics
----------------
ARP Tunnel Pkts sent:0
ARP Tunnel Pkts Rcvd:0
ARP-sync Pkts Sent:0
ARP-sync Pkts Rcvd:0
ARP Reg Request sent:19
ARP Reg Request rcvd:10
Related Commands show vlt statistics — displays statistics on VLT operations.
delay-restore
Congure the delay in bringing up VLT ports after reload or peer-link restoration between the VLT peer switches.
Syntax
delay-restore
Parameters
delay-restore Enter the amount of time, in seconds, to delay bringing up the VLT ports after the
VLTi device reloads or after the peer-link restores between VLT peer switches. The
range from 1 to 1200. The default is 90 seconds.
Defaults Not congured.
Command Modes VLT DOMAIN
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
Virtual Link Trunking (VLT)
1591