Users Guide

proxy-gateway static
Enables the proxy-gateway feature using static congurations.
S3048–ON
Syntax
[no] proxy-gateway static
Command Modes VLT DOMAIN
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Introduced on the S4810, S4820T, S6000, Z9000.
Usage Information
When you add a proxy-gateway static conguration, the setting is saved in the Layer 2 module. When you
remove the static proxy gateway conguration, each proxy-gateway static MAC congured is deleted from
the Layer 2 module.
Example
Dell(conf)#vlt-domain 1
Dell(conf-vlt-domain#proxy-gateway static
remote-mac-address exclude-vlan
Congure the proxy-gateway static entry and exclude a VLAN or a range of VLANs from proxy routing.
S3048–ON
Syntax
[no] remote-mac-address mac—address [exclude-vlan vlan-range]
Parameters
remote-mac-
address
Specify the mac-addresses of the VLT peers which are in the remote VLT domain.
mac-address Enter the 48-bit hexadecimal address in nn:nn:nn:nn:nn:nn format.
vlan-range
Enter the VLAN IDs in which proxy gateway is not needed. The VLANs are
excluded from doing proxy gateway. The value can be a single VLAN ID, comma-
separated VLAN IDs, a range of VLAN IDs, or a combination. For example:
Comma-separated: 3, 4, 6
Range: 5-10
1584
VLT Proxy Gateway