Users Guide
Version Description
9.5(0.0) Introduced on the Z9500.
9.4.(0.0) Introduced on the S-Series and Z9000.
Usage Information
When you use this command, the management ports corresponding to both the active unit and the standby
unit are associated with the management VRF.
maximum dynamic-routes
Specify the maximum number of dynamic (protocol) routes a VRF can have.
Syntax
maximum dynamic-routes limit {warn-threshold threshold-value | warning-
only}
To remove the limit on the maximum number of routes used, use the no maximum dynamic-routes
command.
Parameters
limit Maximum number of routes allowed in a VRF. The valid range is from 1 to 16,000
(or maximum allowable for that platform if a smaller value).
warning-threshold The warning threshold value is a percentage of the limit value. When the number of
routes reaches the specied percentage of the limit, a warning message appears.
The valid range is from 1 to 100.
After the limit is reached, additional dynamic routes are not allowed.
warning-only When you use the warning-only option, when the maximum number of
dynamic routes reaches the limit, a warning message appears.
After the limit is reached, additional dynamic routes are still allowed.
Defaults No limit is set on the maximum number of dynamic routes for a VRF.
Command Modes CONFIGURATION-VRF
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell
Networking Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON and Z9500.
9.4(0.0) Introduced on the S–Series.
1580
Virtual Routing and Forwarding (VRF)