Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S3048-ON

1571

Command History

This guide is platform-specic. For command information about other platforms, see the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–ON, and Z9500.

Usage Information It is possible to congure multiple import conditions per VRF depending on the exporting VRF.

The export-target and import-target support only the match protocol and match prex-list options. Other

options that are congured in the route-maps are ignored.

Related Commands ip route-export – exports routes to another VRF.

ipv6 route-export

Enables route leaking between VRFs. This command exports or shares IPv6 routes corresponding to one VRF with other nondefault

VRFs.

Syntax

ipv6 route-export tag [route-map-name]

Parameters

route-export Enter the keywords route-export to leak or share routes between VRFs.

tag Enter a tag (ASN number) as the export route target to expose routes to other

VRFs. This tag acts as an identier for exported routes. Use this identier while

importing these routes into another nondefault VRF.

route-map-name (Optional) Enter the name of the route-map to lter the exported routes. You can

leak global routes to be made available to VRFs. As the global RTM usually contains

a large pool of routes, when the destination VRF imports global routes, these

routes are duplicated into the VRF's RTM. As a result, it is mandatory to use route-

maps to lter out leaked routes while sharing global routes with VRFs.

Defaults N/A

Command Modes

• VRF mode

• CONFIGURATION mode