Users Guide
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.4.(0.0) Introduced on the S-Series.
ip vrf forwarding
Attach an interface to a VRF.
Syntax
ip vrf forwarding {vrf-name | management}
To delete an interface associated with a congured VRF, use the no ip vrf forwarding {vrf-name
| management} command.
Parameters
vrf-name Enter name of the VRF that you want to associate the interface to.
management Enter the keyword management to associate an interface to the management
VRF.
Defaults none
Command Modes INTERFACE-CONFIG
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON and Z9500.
9.4.(0.0) Introduced on the S-Series and Z9000.
Usage Information
You can attach an interface to either a nondefault VRF or a management VRF.
To assign a port-back to a default VRF, remove the VRF association from the interface. You can use this only
if there is no IP address congured on the interface.
There must be no prior Layer 3 conguration on the interface when conguring VRF.
You must enable VRF before using this command.
Virtual Routing and Forwarding (VRF)
1573