Users Guide

Related Commands
• uplink-state-group — creates an uplink-state group and enables the tracking of upstream links.
show running-cong uplink-state-group
Display the current conguration of one or more uplink-state groups.
Syntax
show running-config uplink-state-group [group-id]
Parameters
group-id Displays the current conguration of all uplink-state groups or a specied group.
The valid group-id values are from 1 to 16.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.4.2.3 Introduced on the S-Series S50.
Example
Dell#show running-config uplink-state-group
!
no enable
uplink state track 1
downstream GigabitEthernet 1/2,4,6,11-19
upstream TengigabitEthernet 1/49, 50
upstream PortChannel 1
!
uplink state track 2
downstream GigabitEthernet 1/1,3,5,7-10
upstream TengigabitEthernet 1/51,52
Related Commands
• show uplink-state-group — displays the status information on a specied uplink-state group or all
groups.
• uplink-state-group — creates an uplink-state group and enables the tracking of upstream links.
1556
Uplink Failure Detection (UFD)