Manualshelf

Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S3048-ON
1531153215331534153515361537153815391540
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
ntp multicast client
To receive NTP information from the network via multicast, congure the switch.
Syntax
ntp multicast client [multicast-address]
To disable multicast reception, use the no ntp multicast client [multicast-address]
command.
Parameters
multicast-address (OPTIONAL) Enter a multicast address. Enter either an IPv4 address in dotted
decimal format or an IPv6 address in X:X:X:X::X format. If you do not enter a
multicast address, the address:
• 224.0.1.1 is congured if the interface address is IPv4
• 05::101 is congured if the interface address is IPv6
Defaults Not congured.
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
System Time and Date
1533