Users Guide
Version Description
6.2.1.1 Introduced on the E-Series.
bpdu-destination-mac-address
Use the Provider Bridge Group address in Spanning Tree or GVRP PDUs.
Syntax
bpdu-destination-mac-address [stp | gvrp] provider-bridge-group
Parameters
xstp Force STP, RSTP, and MSTP to use the Provider Bridge Group address as the
destination MAC address in its BPDUs.
gvrp Forces GVRP to use the Provider Bridge GVRP Address as the destination MAC
address in its PDUs.
Defaults The destination MAC address for BPDUs is the Bridge Group Address.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series and S-Series.
debug spanning-tree
Enable debugging of the spanning tree protocol and view information on the protocol.
Syntax
debug spanning-tree {stp-id [all | bpdu | config | events | exceptions |
general | root] | protocol}
To disable debugging, use the no debug spanning-tree command.
Parameters
stp-id Enter zero (0). The switch supports one spanning tree group with a group ID of 0.
1496
Spanning Tree Protocol (STP)