Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S3048-ON

1491

Command History

This guide is platform-specic. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-

Mux (PMUX) mode only.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.6.1.0 Introduced on the C-series and S-Series.

Usage Information Broadcast trac (all 0xFs) should be counted against the broadcast storm control meter, not against the

multicast storm control meter. It is possible, however, that some multicast control trac may get dropped

when storm control thresholds are exceeded.

storm-control multicast (Interface)

Congure the percentage of multicast trac allowed on an C-Series or S-Series interface (ingress only) network only.

Syntax

storm-control multicast packets_per_second in

To disable multicast storm control on the interface, use the no storm-control multicast

packets_per_second in command.

Parameters

packets_per_secon

d in

Enter the packets per second of broadcast trac allowed into the network. The

range is from 0 to 33554368.

Defaults none

Command Modes INTERFACE (conf-if-interface-slot/port)