Users Guide

To disable broadcast rate-limiting, use the storm-control broadcast [percentage decimal_value in | out] |
[wred-prole name]] [packets_per_second in] command.
Parameters
percentagedecimal
_value in | out
Enter the percentage of broadcast trac allowed in or out of the network.
Optionally, you can designate a decimal value percentage, for example, 55.5%. The
decimal range is from .1 to .9.
wred-prole name Enter the keyword wred-prole followed by the prole name to designate a wred-
prole.
packets_per_secon
d in
Enter the packets per second of broadcast trac allowed into the network. The
range is from 0 to 33554368.
Defaults none
Command Modes CONFIGURATION (conf)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 E-Series Only: Added the percentage decimal value option.
6.5.1.0 Introduced on the E-Series.
Usage Information Broadcast storm control is valid on Layer 2/Layer 3 interfaces only. Layer 2 broadcast trac is treated as
unknown-unicast trac.
storm-control broadcast (Interface)
Congure the percentage of broadcast trac allowed on an interface (ingress only).
Syntax
storm-control broadcast [packets_per_second in]
Storm Control
1489