Users Guide
Example
Dell(conf)#show logging audit
Related Commands clear logging auditlog — clears audit log.
show logging driverlog stack-unit
Display the driver log for the specied hardware component.
Syntax
show logging driverlog {cp | rp | linecard slot-id]
Parameters
stack-unit stack-
unit-number
Enter the keywords stack-unit followed by the stack member ID of the switch
for which you want to display the driver log.
defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
Usage Information This command displays internal software driver information, which may be useful during troubleshooting
switch initialization errors, such as a downed Port-Pipe.
terminal monitor
Congure the Dell Networking OS to display messages on the monitor/terminal.
Syntax
terminal monitor
To return to default settings, use the terminal no monitor command.
defaults Disabled.
1466
Simple Network Management Protocol (SNMP) and Syslog