Users Guide
Example
Dell(conf)#logging version ?
<0-1> Select syslog version (default = 0)
Dell(conf)#logging version 1
show logging
Display the logging settings and system messages logged to the internal buer of the switch.
Syntax
show logging [number | history [reverse][number] | reverse [number] |
summary]
Parameters
number (OPTIONAL) Enter the number of messages displayed in the output. The range is
from 1 to 65535.
history (OPTIONAL) Enter the keyword history to view only information in the Syslog
history table.
reverse (OPTIONAL) Enter the keyword reverse to view the Syslog messages in FIFO
(rst in, rst out) order.
summary (OPTIONAL) Enter the keyword summary to view a table showing the number of
messages per type and per slot. Slots *7* and *8* represent RPMs.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Example (Partial)
Dell#show logging
Syslog logging: enabled
1464
Simple Network Management Protocol (SNMP) and Syslog