Users Guide

Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage Information Syslog messages contain the IP address of the interface used to egress the router. By conguring the
logging source-interface command, the Syslog packets contain the IP address of the interface
congured.
Related Commands
logging — enables logging to the Syslog server.
logging synchronous
Synchronize unsolicited messages and Dell Networking OS output.
Syntax
logging synchronous [level level | all] [limit number-of-buffers]
To disable message synchronization, use the no logging synchronous [level level | all]
[limit number-of-buffers] command.
Parameters
all Enter the keyword all to ensure that all levels are printed asynchronously.
level level Enter the keyword level then a number as the severity level. A high number
indicates a low severity level and vice versa. The range is from 0 to 7. The default is
2.
all Enter the keyword all to turn o all.
limit number-of-
buers
Enter the keyword limit then the number of buers to be queued for the
terminal after which new messages are dropped. The range is from 20 to 300. The
default is 20.
Defaults Disabled. If enabled without the level or number-of-buffers options specied, level = 2 and number-
of-buers = 20 are the defaults.
Command Modes LINE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
Simple Network Management Protocol (SNMP) and Syslog
1461