Users Guide

Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage Information When you decrease the buer size, all messages stored in the buer are lost. Increasing the buer size does
not aect messages stored in the buer.
Related Commands
clear logging — clears the logging buer.
default logging buered — returns the logging buered parameters to the default setting.
show logging — displays the logging setting and system messages in the internal buer.
logging console
Specify which messages are logged to the console.
Syntax
logging console [level]
To return to the default values, use the default logging console command.
To disable logging to the console, use the no logging console command.
Parameters
level (OPTIONAL) Indicate a value from 0 to 7 or enter one of the following parameters:
emergencies, alerts, critical, errors, warnings, notifications,
informational, or debugging. The default is 7 or debugging.
Defaults level = 7; size = debugging
Command Modes CONFIGURATION
Simple Network Management Protocol (SNMP) and Syslog
1453