Users Guide

Version Description
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Related Commands logging trap — limit messages logged to the Syslog servers based on severity.
logging
Congure an IP address or host name of a Syslog server where logging messages are sent. Multiple logging servers of both IPv4
and/or IPv6 can be congured.
Syntax
logging {ip-address | ipv6-address | hostname} {{udp {port}} | {tcp {port}}
To disable logging, use the no logging command.
Parameters
ip-address Enter the IPv4 address in dotted decimal format.
ipv6-address Enter the IPv6 address in the x:x:x:x::X format.
NOTE: The :: notation species successive hexadecimal elds of zeros.
hostname Enter the name of a host already congured and recognized by the switch.
udp Enter the keyword udp to enable transmission of log message over UDP followed
by port number. The default port is 514
tcp Enter the keyword tcp to enable transmission of log message over TCP followed
by port number.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
Simple Network Management Protocol (SNMP) and Syslog
1451