Users Guide

Example
Dell# conf
Dell#(conf) snmp-server view rview 1.3.6.1 included
Related Commands show running-cong snmp — displays the SNMP running conguration.
snmp-server vrf
Congures an SNMP agent to bind to a specic VRF.
Syntax
snmp-server vrf vrf-name
To undo the SNMP agent conguration, use the no snmp-server vrf vrf-name command.
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF to associate an SNMP
agent with that VRF.
Defaults Not Enabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S-Series and Z9000.
Usage Information
Use this command to bind an SNMP agent to a VRF. The SNMP agent processes the requests from the
interfaces that belong to the specied VRF. If no VRF is specied, then the default VRF is used.
Related Commands show snmp user — displays the information congured on each SNMP user name.
snmp trap link-status
Enable the interface to send SNMP link traps, which indicate whether the interface is up or down.
Syntax
snmp trap link-status
To disable sending link trap messages, use the no snmp trap link-status command.
Defaults Enabled.
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1446
Simple Network Management Protocol (SNMP) and Syslog