Users Guide

Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Authentication key length increased to 42 characters.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.0 Introduced on the E-Series.
Usage Information
The key congured on the switch must match the key congured on the RADIUS server daemon.
If you congure the key parameter in the radius-server host command, the key congured with the
radius-server key command is the default key for all RADIUS communications.
Related Commands radius-server host — congures a RADIUS host.
radius-server retransmit
Congure the number of times the switch attempts to connect with the congured RADIUS host server before declaring the
RADIUS host server unreachable.
Syntax
radius-server retransmit retries
To congure zero retransmit attempts, use the no radius-server retransmit command.
To return to the default setting, use the radius-server retransmit 3 command.
Parameters
retries Enter a number of attempts that FTOS tries to locate a RADIUS server. The range
is from zero (0) to 100. The default is 3 retries.
Defaults 3 retries
Command Modes CONFIGURATION
Security
1349