Users Guide

privilege level (CONFIGURATION mode)
Change the access or privilege level of one or more commands.
Syntax
privilege mode {level level command | reset command}
To delete access to a level and command, use the no privilege mode level level command
command.
Parameters
mode Enter one of the following keywords as the mode for which you are controlling
access:
• configure for CONFIGURATION mode
• exec for EXEC mode
•
interface for INTERFACE modes
• line for LINE mode
• route-map for ROUTE-MAP mode
• router for ROUTER OSPF, ROUTER RIP, ROUTER ISIS and ROUTER BGP
modes
level level Enter the keyword level then a number for the access level. The range is from 0
to 15.
Level 1 is EXEC mode and Level 15 allows access to all CLI modes and commands.
reset Enter the keyword reset to return the security level to the default setting.
command Enter the command’s keywords to assign the command to a certain access level.
You can enter one or all of the keywords.
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Security
1323