Users Guide

NOTE: This parameter is available but not supported in Dell Networking
Operating System version 8.3.11.4. Because stacking is not supported, if
you use this parameter, the output displays “Media not present or
accessible” (refer to the Usage Information section).
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.4 Output expanded to include Piece Part ID (PPID) and eSR4 optics.
8.3.11.1 Introduced on the Z9000.
7.6.1.0 Introduced this version of the command for S-Series. S-Series output diers from
E-Series.
Usage Information If there are no ber ports in the unit, just the header under show inventory media displays. If there are ber
ports but no optics inserted, the output displays Media not present or accessible.
Example (S6000)
Dell#show inventory
System Type : S6000
System Mode : 1.0
Software Version : 9-4(0-168)
Unit Type Serial Number Part Number Rev Piece Part ID
Rev SvcTag Exprs Svc Code
----------------------------------------------------------
* 0 S6000-01-FE-32T NA 08YWFG A00 CN-08YWFG-28298-39Q-0015
A00 24N1VS1 463 414 838 5
0 S6000-PWR-AC NA 0T9FNW A00 CN-0T9FNW-28298-39Q-0005
A00 NA NA
0 S6000-FAN NA 0MGDH8 A00 CN-0MGDH8-28298-39Q-0009
A00 NA NA
0 S6000-FAN NA 0MGDH8 A00 CN-0MGDH8-28298-39Q-0007
A00 NA NA
0 S6000-FAN NA 0MGDH8 A00 CN-0MGDH8-28298-39Q-0008
A00 NA NA
* - Management Unit
Software Protocol Configured
Control and Monitoring
131