Users Guide

Field Description
Status (Allowed
ports)
Indicates if the input policy map conguration on an interface belonging to a stack-
unit/port-pipe is successful — Allowed (n) — or not successful — Exception. The
allowed number (n) indicates the number of ports in that port-pipe on which the
Policy Map can be applied successfully.
NOTE: In a Layer 2 Policy Map, IPv4/IPv6 rules are not allowed; therefore, the output contains
only L2ACL CAM partition entries.
Example
Dell# test cam-usage service-policy input pmap_l2 stack-unit all
For a L2 Input Policy Map pmap_l2, the output must be as follows,
stack-unit|Portpipe|CAM Partition|Available CAM|Estimated CAM|Status
| | | |per Port |(Allowed
ports)
0 0 L2ACL 500 200 Allowed (2)
0 1 L2ACL 100 200 Exception
1 0 L2ACL 1000 200 Allowed (5)
1 1 L2ACL 0 200 Exception
…
…
…
13 1 L2ACL 400 200 Allowed (2)
Dell#
threshold
Specify the minimum and maximum threshold values for the congured WRED proles.
S3048–ON
Syntax
threshold min number max number max-drop-probability
To remove the threshold values, use the no threshold min number max number command.
Parameters
min number Enter the keyword min then the minimum threshold number for the WRED prole.
The range is from 1 to 9360.
max number Enter the keyword max then the maximum threshold number for the WRED prole.
The range is from 1 to 9360 KB.
max-drop-
probability number
Enter the keyword max-drop-probability followed by the maximum number of
packets for the WRED prole. The range is from 0 to 100 KB
Defaults none
Command Modes CONFIGURATION (cong-wred)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
1246
Quality of Service (QoS)