Users Guide

Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Policy name character limit increased from 16 to 32.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.1 Introduced on the E-Series.
Usage Information An aggregate output QoS policy applies to all outbound port trac. An aggregate output QoS policy can
coexist with per-queue output QoS policies. If the rate shape exists in both aggregate and per-queue qos-
policy, minimum of 2 take eect. Some of all Queue-rate will not exceed aggregate.
Related Commands
policy-map-input — creates an input policy map.
policy-map-output — creates an output policy map.
policy-map-input
Create an input policy map.
S3048–ON
Syntax
policy-map-input policy-map-name cpu-qos | [layer2] [cpu-qos]
To remove an input policy map, use the no policy-map-input policy-map-name cpu-qos |
[layer2] [cpu-qos] command.
Parameters
policy-map-name Enter the name of the policy map in character format (32 characters
maximum).
cpu-qos Enter the cpu-qos keyword to assign this ACL to control plane trac only.
layer2 (OPTIONAL) Enter the keyword layer2 to specify a Layer 2 Class Map. The
default is Layer 3.
cpu-qos (OPTIONAL) Enter the keyword cpu-qos to create an input policy to be used to
rate-limit control-plane trac (CoPP).
Defaults Layer 3
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
Quality of Service (QoS)
1223