Users Guide

rate police
Police the incoming trac rate on the selected interface.
S3048–ON
Syntax
rate police [kbps] committed-rate [burst-KB] [peak [kbps] peak-rate [burst-
KB]] [vlan vlan-id]
Parameters
kbps Enter the keyword kbps to specify the rate limit in Kilobits per second (Kbps). The
range is from 0 to 40000000. The default granularity is Megabits per second
(Mbps).
committed-rate Enter the bandwidth in Mbps. The range is from 0 to 40000.
burst-KB (OPTIONAL) Enter the burst size in KB. The range is from 16 to 200000. The
default is 50.
peak peak-rate (OPTIONAL) Enter the keyword peak then a number to specify the peak rate in
Mbps. The range is from 0 to 40000.
vlan vlan-id (OPTIONAL) Enter the keyword vlan then a VLAN ID to police trac to those
specic VLANs. The range is from 1 to 4094.
Defaults Granularity for commited-rate and peak-rate is Mbps unless you use the kbps option.
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added the kbps option on the C-Series, E-Series, and S-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.1 Introduced on the E-Series.
Usage Information
NOTE: Per Port rate police is supported for Layer 2 tagged and untagged switched trac and for
Layer 3 trac. Per VLAN rate police is supported on only tagged ports with Layer 2 switched
trac.
1206
Quality of Service (QoS)