Users Guide

reload
Reboot Dell Networking Operating System (OS).
Syntax
reload [conditional nvram-cfg-change]
Parameters
conditional nvram-
cfg-change
Reload if the condition is true. A conguration change to the nvram requires a
switch reload. To reload the switch, select nvram-cfg-change.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
9.1(0.0) Added ‘conditional’ parameter.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage Information If there is a change in the conguration, the system prompts you to save the new conguration. Or you can
save your running conguration with the copy running-config command. Use the conditional
parameter if any conguration changes made to the nvram, such as stack-group and fanout congurations,
must be saved.
send
Send messages to one or all terminal line users.
Syntax
send [*] | [line ] | [console] | [vty]
Parameters
* Enter the asterisk character * to send a message to all tty lines.
line Send a message to a specic line. The range is from 0 to 11.
console Enter the keyword console to send a message to the primary terminal line.
120
Control and Monitoring