Users Guide

source (port monitoring)
Congure a port monitor source.
Syntax
source {interface | range | any} destination interface direction {rx | tx |
both}
To disable a monitor source, use the no source interface destination interface
direction {rx | tx | both} command.
Parameters
source interface Enter one of the following keywords and slot/port information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
then the slot/port information.
•
For a VLAN interface enter the keyword VLAN followed by a number from 1 to
4094.
• For a port channel interface, enter the keywords port-channel then a
number.
range Enter the keyword range to specify the list of interfaces.
any Enter the keyword any to specify all interfaces.
NOTE: This option is applicable only with drop monitor session.
destination Enter the keyword destination to specify the destination interface.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a port channel interface, enter the keywords port-channel then a
number.
interface Enter one of the following keywords and slot/port information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
•
For a port channel interface, enter the keywords port-channel then a
number.
direction {rx | tx |
both}
Enter the keyword direction then one of the packet directional indicators.
• rx: to monitor receiving packets only.
• tx: to monitor transmitting packets only.
• both: to monitor both transmitting and receiving packets.
Defaults none
Command Modes MONITOR SESSION (conf-mon- sess-session-ID)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
1180
Port Monitoring