Users Guide

Version Description
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the S-Series.
Usage Information The following describes the show ip pim tib command shown in the following example.
Field Description
(S, G) Displays the entry in the multicast PIM database.
uptime Displays the amount of time the entry has been in the PIM route table.
expires Displays the amount of time until the entry expires and is removed from the
database.
RP Displays the IP address of the RP/source for this entry.
ags List the ags to dene the entries:
• D = PIM Dense Mode
• S = PIM Sparse Mode
• C = directly connected
• L = local to the multicast group
• P = route was pruned
• R = the forwarding entry is pointing toward the RP
• F = Dell Networking OS is registering this entry for a multicast source
• T = packets were received via Shortest Tree Path
• J = rst packet from the last hop router is received and the entry is ready to
switch to SPT
• K = acknowledge pending state
Incoming interface Displays the reverse path forwarding (RPF) interface towards the RP/ source.
RPF neighbor Displays the next hop from this interface towards the RP/source.
Outgoing interface
list:
Lists the interfaces that meet one of the following criteria:
• a directly connect member of the Group
• statically congured member of the Group
• received a (*,G) Join message
Example
Dell#do show ip pim tib
PIM Multicast Routing Table
Flags: D - Dense, S - Sparse, C - Connected, L - Local, P - Pruned,
R - RP-bit set, F - Register flag, T - SPT-bit set, J - Join SPT,
M - MSDP created entry, A - Candidate for MSDP Advertisement
K - Ack-Pending State
Timers: Uptime/Expires
Interface state: Interface, next-Hop, State/Mode
(*, 225.1.1.1), uptime 00:40:16, expires 00:00:00, RP 20.40.4.4, flags: SCJ
Incoming interface: Vlan 2007, RPF neighbor 20.30.124.4
Outgoing interface list:
Vlan 2006 Forward/Sparse 00:06:21/Never
PIM-Sparse Mode (PIM-SM)
1171