Users Guide
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.5(0.1) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.4.1.1 Introduced on the E-Series ExaScale.
Usage Information The following describes the show ip pim snooping tib commands shown in the following example.
Field Description
(S, G) Displays the entry in the PIM multicast snooping database.
uptime Displays the amount of time the entry has been in the PIM multicast route table.
expires Displays the amount of time until the entry expires and is removed from the
database.
RP Displays the IP address of the RP/source for this entry.
ags List the ags to dene the entries:
• S = PIM Sparse Mode
• C = directly connected
• L = local to the multicast group
• P = route was pruned
• R = the forwarding entry is pointing toward the RP
• F = Dell Networking OS is registering this entry for a multicast source
• T = packets were received via Shortest Tree Path
• J = rst packet from the last hop router is received and the entry is ready to
switch to SPT
• K=acknowledge pending state
Incoming interface Displays the reverse path forwarding (RPF) interface towards the RP/ source.
RPF neighbor Displays the next hop from this interface towards the RP/source.
Outgoing interface
list:
Lists the interfaces that meet one of the following criteria:
• a directly connect member of the Group
• statically congured member of the Group
• received a (*,G) Join message
PIM-Sparse Mode (PIM-SM)
1167