Users Guide

To remove an RP address, use the no ip pim [vrf vrf-name] rp-address address {group-
address group-address mask} [override] command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF.
NOTE: Applies to specic VRF if input is provided, else applies to Default
VRF.
address Enter the RP address in dotted decimal format (A.B.C.D).
group-address
group-address
mask
Enter the keywords group-address then a group-address mask, in dotted
decimal format (/xx), to assign that group address to the RP.
override Enter the keyword override to override the BSR updates with static RP. The
override takes eect immediately during enable/disable.
NOTE: This option is applicable to multicast group range.
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the S-Series.
pre- 6.1.1.1 Introduced on the E-Series.
Usage Information First-hop routers use this address by to send register packets on behalf of source multicast hosts. The RP
addresses are stored in the order in which they are entered. The RP is chosen based on a longer prex
match for a group. The RP selection does not depend on dynamic or static RP assignments.
ip pim rp-candidate
To send out a Candidate-RP-Advertisement message to the bootstrap (BS) router or dene group prexes that are dened with the
RP address to PIM BSR, congure a PIM router.
Syntax
ip pim [vrf vrf-name] rp-candidate {interface [priority]}
1154
PIM-Sparse Mode (PIM-SM)