Users Guide
ip pim register-lter
To prevent a PIM source DR from sending register packets to an RP for the specied multicast source and group, use this feature.
Syntax
ip pim [vrf vrf-name] register-filter access-list
To return to the default, use the no ip pim [vrf vrf-name] register-filter access-list
command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF.
NOTE: Applies to specic VRF if input is provided, else applies to Default
VRF.
access-list Enter the name of an extended access list. Maximum 16 characters.
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the C-Series and S-Series.
7.6.1.0 Introduced
Usage Information The access name is an extended IP access list that denies PIM register packets to RP at the source DR
based on the multicast and group addresses. Do not enter this command before creating the access-list.
ip pim rp-address
Congure a static PIM rendezvous point (RP) address for a group or access-list.
Syntax
ip pim [vrf vrf-name] rp-address address {group-address group-address mask}
[override]
PIM-Sparse Mode (PIM-SM)
1153