Users Guide

ip-address Enter the keyword IP address of the forwarding router.
tunnel Enter the keyword tunnel to congure the tunnel setting.
tunnel-id Enter the keyword tunnel-id to redirect the trac.
track Enter the keyword track to enable the tracking.
track <obj-id> Enter the keyword track <obj-id> to track object-id.
ip-protocol-number Enter the keyword ip-protocol-number then the number from 0 to 255 for
the protocol identied in the IP protocol header.
protocol-type Enter one of the following keywords as the protocol type:
• icmp for internet control message protocol
• ip for any internet protocol
• tcp for transmission control protocol
• udp for user datagram protocol
source Enter the IP address of the network or host from which the packets were sent.
mask Enter a network mask in /prex format (/x).
any Enter the keyword any to specify that all trac is subject to the lter.
host ip-address Enter the keyword host then the IP address to specify a host IP address.
destination Enter the IP address of the network or host to which the packets are sent.
bit (OPTIONAL) For the TCP protocol type only, enter one or a combination of the
following TCP ags:
• ack = acknowledgement
• fin = nish (no more data from the user)
•
psh = push function
• rst = reset the connection
• syn = synchronize sequence number
• urg = urgent eld
operator (OPTIONAL) For the TCP and UDP parameters only. Enter one of the following
logical operand:
• eq = equal to
• neq = not equal to
•
gt = greater than
• lt= less than
• range = inclusive range of ports (you must specify two ports for the port
command parameter.)
source port Enter the keywords source-port then the port number to be matched in the
ACL rule in the ICAP rule
destination-port Enter the keywords destination-port then the port number to be matched in
the ACL rule in the ICAP rule.
source-port-range Enter the keywords Source-port-range then the range of the start port to
end port to be matched in the ACL rule in the ICAP rule.
1140
Policy-based Routing (PBR)