Users Guide

Command History
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.1.(0.0) Introduced support for OSPFv3 on the S4810 and Z9000.
8.3.19.0 Introduced on the S4820T.
7.8.1.0 Added support for the C-Series.
7.4.1.0 Introduced on the E-Series.
Example
Dell#show ipv6 ospf 3 neighbor gi 1/2
Neighbor ID Pri State Dead Time Interface ID Interface
63.114.8.36 1 FULL/DR 00:00:38 4 Gi 1/2
Dell#
timers spf
Set the time interval between when the switch receives a topology change and starts a shortest path rst (SPF) calculation.
S3048–ON
Syntax
timers spf delay holdtime
To return to the default, use the no timers spf command.
Parameters
delay Enter a number as the delay. The range is from 0 to 4294967295. The default is 5
seconds.
holdtime Enter a number as the hold time. The range is from 0 to 4294967295. The default
is 10 seconds.
Defaults
• delay = 5 seconds
• holdtime = 10 seconds
Command Modes ROUTER OSPFv3 for OSPFv3
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.8(0.0) Introduced on the S6000-ON, S6000, S4820T, S4810, S5000.
Usage Information Setting the delay and holdtime parameters to a low number enables the switch to an alternate path quickly
but requires more CPU usage.
1132
Open Shortest Path First (OSPFv2 and OSPFv3)