Users Guide

hold-interval Set the next interval to send the same LSA. This interval is the time between
sending the same LSA after the start-interval has been attempted. The range is
from 1 to 600,000 milliseconds.
max-interval Set the maximum amount of time the system waits before sending the LSA. The
range is from 1 to 600,000 milliseconds.
Defaults
• start-interval: 0 msec
• hold-interval: 5000 msec
• max-interval: 5000 msec
Command Modes ROUTER OSPF
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
9.0.2.0 Introduced on the S6000..
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Introduced on the S4810.
Usage Information LSAs are sent after the start-interval and then after hold-interval until the maximum interval is reached. In
throttling, exponential backo is used when sending same LSA, so that the interval is multiplied until the
maximum time is reached. For example, if the start-interval 5000 and hold-interval 1000 and max-interval
100,000, the LSA is sent at 5000 msec, then 1000 msec, then 2000 msec, them 4000 until 100,000 msec is
reached.
timers throttle lsa arrival
Congure the LSA acceptance intervals.
Syntax
timers throttle lsa arrival arrival-time
To return to the default, use the no timers throttle lsa command.
Parameters
arrival-time Set the interval between receiving the same LSA repeatedly, to allow sucient time
for the system to accept the LSA. The range is from 0 to 600,000 milliseconds.
Defaults 1000 msec
1100
Open Shortest Path First (OSPFv2 and OSPFv3)