Users Guide

Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant FTOS
Command Line Reference Guide.
The following is a list of the FTOS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.4.(0.0) Introduced on the S-Series and Z9000.
Usage Information If you congure a TELNET client to use a specic VRF, then you need not explicitly specify the same VRF
during the TELNET client sessions corresponding to that VRF.
Example
Dell(conf)#ip telnet vrf vrf1
Dell(conf)#do telnet 10.10.10.2
Dell(conf)#no ip telnet vrf vrf1
ip tftp source-interface
Assign an interface’s IP address in outgoing packets for TFTP trac.
Syntax
ip tftp source-interface interface
To return to the default setting, use the no ip tftp source-interface interface command.
Parameters
interface Enter the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
•
For a port channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults The IP address on the system that is closest to the Telnet address is used in the outgoing packets.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
110
Control and Monitoring