Users Guide

Command Modes ROUTER OSPF
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Added support for Multi-Process OSPF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.1 Introduced on the E-Series.
Usage Information Setting the delay and holdtime parameters to a low number enables the switch to an alternate path quickly
but requires more CPU usage.
Example
Dell#
Dell#conf
Dell(conf)#router ospf 1
Dell(conf-router_ospf-1)#timer spf 2 5
Dell(conf-router_ospf-1)#
Dell(conf-router_ospf-1)#show config
!
router ospf 1
timers spf 2 5
Dell(conf-router_ospf-1)#
Dell(conf-router_ospf-1)#end
Dell#
Dell#
timers throttle lsa all
Congure LSA transmit intervals.
Syntax
timers throttle lsa all {start-interval | hold-interval | max-interval}
To return to the default, use the no timers throttle lsa command.
Parameters
start-interval Set the minimum interval between initial sending and resending the same LSA. The
range is from 0 to 600,000 milliseconds.
Open Shortest Path First (OSPFv2 and OSPFv3)
1099