Users Guide

Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Added support for Multi-Process OSPF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.1 Introduced on the E-Series.
Usage Information The following describes the show ip ospf process-id interface command shown in the
following example.
Item Description
GigabitEthernet... This line identies the interface type slot/port and the status of the OSPF protocol
on that interface.
Internet Address... This line displays the IP address, network mask and area assigned to this interface.
Process ID... This line displays the OSPF Process ID, Router ID, Network type and cost metric
for this interface.
Transmit Delay... This line displays the interface’s settings for Transmit Delay, State, and Priority. In
the State setting, BDR is Backup Designated Router.
Designated Router... This line displays the ID of the Designated Router and its interface address.
Backup
Designated...
This line displays the ID of the Backup Designated Router and its interface address.
Timer intervals... This line displays the interface’s timer settings for Hello interval, Dead interval,
Transmit Delay (Wait), and Retransmit Interval.
Hello due... This line displays the amount time until the next Hello packet is sent out this
interface.
Neighbor Count... This line displays the number of neighbors and adjacent neighbors. Listed below
this line are the details about each adjacent neighbor.
Example
Dell>show ip ospf int
GigabitEthernet 1/7 is up, line protocol is up
Internet Address 192.168.1.2/30, Area 0.0.0.1
Process ID 1, Router ID 192.168.253.2, Network Type BROADCAST, Cost: 1
Transmit Delay is 1 sec, State DR, Priority 1
Designated Router (ID) 192.168.253.2, Interface address 192.168.1.2
Backup Designated Router (ID) 192.168.253.1, Interface address
192.168.1.1
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Hello due in 00:00:02
Neighbor Count is 1, Adjacent neighbor count is 1
Adjacent with neighbor 192.168.253.1 (Backup Designated Router)
GigabitEthernet 1/8 is up, line protocol is up
Internet Address 192.168.0.1/24, Area 0.0.0.1
Process ID 1, Router ID 192.168.253.2, Network Type BROADCAST, Cost: 1
Transmit Delay is 1 sec, State DROTHER, Priority 1
Designated Router (ID) 192.168.253.5, Interface address 192.168.0.4
Backup Designated Router (ID) 192.168.253.3, Interface address
192.168.0.2
Open Shortest Path First (OSPFv2 and OSPFv3)
1089