Users Guide
Usage Information Use this command to make the FTP clients VRF-aware. The VRF name that you specify is used by the FTP
client to reach the FTP server. If no VRF name is specied, then the default VRF is used.
ip telnet server enable
Enable the Telnet server on the switch.
Syntax
ip telnet server enable
To disable the Telnet server, use the no ip telnet server enable command.
Defaults Enabled
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Related Commands ip ssh server — enables the secure shell (SSH) server on the system.
ip telnet server vrf
Congures the TELNET server on either a specic VRF or a management VRF.
Syntax
ip telnet server vrf {management | vrf-name}
To undo the TELNET server conguration, use the no ip telnet server [vrf vrf-name]
command.
Control and Monitoring
107