Users Guide

Version Description
7.5.1.0 Introduced on the C-Series.
pre- 6.1.1.1 Introduced on the E-Series.
Usage Information
To enable OSPF on an interface, the network area command must include, in its range of addresses, the
primary IP address of an interface.
NOTE: An interface can be attached only to a single OSPF area.
If you delete all the network area commands for Area 0, the show ip ospf command output does not list
Area 0.
passive-interface
Suppress both receiving and sending routing updates on an interface.
S3048–ON
Syntax
passive-interface {default | interface}
To enable both the receiving and sending routing, use the no passive-interface interface
command.
To return all OSPF interfaces (current and future) to active, use the no passive-interface default
command.
Parameters
default Enter the keyword default to make all OSPF interfaces (current and future)
passive.
interface Enter the following keywords and slot/port or number information:
• For a Gigabit Ethernet interface, enter the keyword GigabitEthernet then
the slot/port information.
• For Port Channel groups, enter the keywords port-channel then a number.
For the C-Series, S-Series, and Z9000, the range is from 1 to 128.
•
For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from 1 to 4094.
Command Modes ROUTER OSPF
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
1060
Open Shortest Path First (OSPFv2 and OSPFv3)