Users Guide

IPv6 Object Tracking Commands
The following section describes the IPv6 object tracking commands.
The following object tracking commands apply to IPv4 and IPv6:
• debug track
• delay
• description
• show running-cong track
• threshold metric
• track interface line-protocol
show track ipv6 route
Display information about all tracked IPv6 routes, including conguration, current tracked state (UP or DOWN), and the clients which
are tracking an object.
Syntax
show track ipv6 route [brief]
Parameters
brief (OPTIONAL) Display a single line summary of information for tracked IPv6 routes.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
8.3.12.0 Introduced on the S4810.
8.4.1.0 Introduced.
Usage Information The following describes the show track ipv6 route command shown in the Example below.
Output Description
Track object-id Displays the number of the tracked object.
Interface type slot/
port, IP route ip-
address, IPv6 route
ipv6-address
Displays the interface type and slot/port number or address of the IPv4/IPv6 route
that is being tracked.
object is Up/Down Up/Down state of tracked object; for example, IPv4 interface, reachability or
metric threshold of an IP route.
number changes,
last change time
Number of times that the state of the tracked object has changed and the time
since the last change in hours:minutes:seconds.
First hop interface Displays the type and slot/port number of the rst-hop interface of the tracked
route.
Tracked by Client that is tracking an object’s state; for example, VRRP.
1022
Object Tracking