Setup Guide
Table Of Contents
- About this Guide
- Install the Hardware
- Install the Chassis
- Rack Mounting Safety Considerations
- Rack Mount the Switch
- Installing the Dell ReadyRails System
- Attaching the Ground Cable (Optional)
- Important Points to Remember
- Installing AC Power Supplies
- Installing a Fan Module
- Installing the SFP+ Optics
- Supply Power and Power Up the System
- After Installing the S3048–ON
- Dell Networking OS
- Technical Specifications
Technical Specifications
This chapter lists the S3048–ON specifications.
NOTE: Operate the system at an ambient temperature not higher than 113°F
(45°C).
CAUTION: Lithium Battery Caution: To avoid the possibility of an explosion,
always replace the battery correctly.
NOTE: Replace the battery only with the same or an equivalent type. Dispose of
the batteries according to the manufacturer's instructions.
Table 3. S3048–ON Chassis Physical Design
Parameter Specifications
Height 1.73 inches (44 mm)
Width 17.09 inches (434 mm)
Depth 12.60 inches (320 mm)
Chassis weight with factory-installed
components
21.7 pounds (approx.) (9.86 kg)
Rack clearance required
Front: 5 inches (12.7 cm)
Rear: 5 inches (12.7 cm)
Table 4. Environmental Parameters
Parameter Specifications
Operating temperature 32° to 113°F (0° to 45°C)
Operating humidity 5 to 85 percent (RH), non-condensing
Storage temperature –40° to 158°F (–40° to 70°C)
Storage and non-operating humidity 5 to 95 percent (RH), non-condensing
Maximum thermal output 1153.265 BTH/hr
Technical Specifications 30