Setup Guide
Table Of Contents
- About this Guide
- Install the Hardware
- Install the Chassis
- Rack Mounting Safety Considerations
- Rack Mount the Switch
- Installing the Dell ReadyRails System
- Attaching the Ground Cable (Optional)
- Important Points to Remember
- Installing AC Power Supplies
- Installing a Fan Module
- Installing the SFP+ Optics
- Supply Power and Power Up the System
- After Installing the S3048–ON
- Dell Networking OS
- Technical Specifications
are in Layer 2 mode, use the show interfaces switchport command in EXEC
Privilege mode or EXEC mode.
Assigning an IP Address to a VLAN
VLANs are a Layer 2 feature. For two physical interfaces on different VLANs to
communicate, assign an IP address to the VLANs to route traffic between the two
interfaces.
The shutdown command in INTERFACE mode for a VLAN does not affect Layer 2
traffic on the VLAN.
NOTE: You cannot assign an IP address to the Default VLAN, which, by default, is
VLAN 1. To assign another VLAN ID to the Default VLAN, use the default
vlan-id vlan-id command from the configuration mode.
• Access INTERFACE VLAN mode of the VLAN to which you want to assign the IP
address then configure an IP addresses and mask on the interface.
INTERFACE mode
ip address ip-address mask [secondary]
Connect the S3048–ON to the Network
After you have completed the hardware installation and software configuration for
the S3048–ON system, connect to your company network by following your
company’s cabling requirements.
Dell Networking OS 29