Setup Guide
Table Of Contents
- About this Guide
- Install the Hardware
- Install the Chassis
- Rack Mounting Safety Considerations
- Rack Mount the Switch
- Installing the Dell ReadyRails System
- Attaching the Ground Cable (Optional)
- Important Points to Remember
- Installing AC Power Supplies
- Installing a Fan Module
- Installing the SFP+ Optics
- Supply Power and Power Up the System
- After Installing the S3048–ON
- Dell Networking OS
- Technical Specifications
interface vlan vlan-id
2 Enable an interface to include the IEEE 802.1Q tag header.
INTERFACE mode
tagged <interface type> interface
<interface type> — Enter the following keywords and slot/port or number
information:
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
then the slot/port information.
• For a Port Channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
This command is available only in VLAN interfaces.
3 Move untagged interfaces. Access INTERFACE VLAN mode of the VLAN to
which you want to assign the interface.
CONFIGURATION mode
interface vlan vlan-id
4 Configure an interface as untagged.
INTERFACE mode
untagged <interface type> interface
<interface type> — Enter the following keywords and slot/port or number
information:
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
then the slot/port information.
• For a Port Channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
This command is available only in VLAN interfaces.
5 To exit Configuration mode, use the exit command.
To view which interfaces are tagged or untagged and to view which VLAN the
interfaces belong, use the show vlan command. To view just the interfaces that
Dell Networking OS 28