Setup Guide
Table Of Contents
- About this Guide
- Install the Hardware
- Install the Chassis
- Rack Mounting Safety Considerations
- Rack Mount the Switch
- Installing the Dell ReadyRails System
- Attaching the Ground Cable (Optional)
- Important Points to Remember
- Installing AC Power Supplies
- Installing a Fan Module
- Installing the SFP+ Optics
- Supply Power and Power Up the System
- After Installing the S3048–ON
- Dell Networking OS
- Technical Specifications
Dell Networking OS
To initially configure the Dell Networking operating system (OS), use the following
sections.
NOTE: This chapter applies ONLY if you already have the Dell Networking OS
installed on your system from the factory. If you are installing a third-party OS,
refer to your third-party OS documentation.
NOTE: For complete installation and configuration information, refer to the
following documents at www.dell.com/support:
• Dell Networking Installation Guide for the S3048–Open Networking (ON)
System.
• Dell Networking Command Line Reference Guide for the S3048–Open
Networking (ON) System.
• Dell Networking Configuration Guide for the S3048–Open Networking (ON)
System.
• Dell Networking Release Notes for the S3048–Open Networking (ON)
System.
Topics:
• Enter the Initial Configuration Information
• Navigating CLI Modes
• Accessing the Console
• Default Configuration
• Configuring Layer 2 (Data Link) Mode
• Configuring a Host Name
• Accessing the System Remotely
• Configuring the Enable Password
• Creating a Port-based VLAN
• Connect the S3048–ON to the Network
3
Dell Networking OS 20