Setup Guide
Table Of Contents
- About this Guide
- Install the Hardware
- Install the Chassis
- Rack Mounting Safety Considerations
- Rack Mount the Switch
- Installing the Dell ReadyRails System
- Attaching the Ground Cable (Optional)
- Important Points to Remember
- Installing AC Power Supplies
- Installing a Fan Module
- Installing the SFP+ Optics
- Supply Power and Power Up the System
- After Installing the S3048–ON
- Dell Networking OS
- Technical Specifications
Figure 8. Install the AC Power Supply Unit
4 Attach the power cables from the switch PSU to the external power source.
NOTE: The system is powered-up as soon as you connect the power cord
between the system and the power source.
5 Repeat steps 1 through 3 for the second PSU.
NOTE
: Ensure that the PSU is correctly installed. When you correctly install the
PSU, the power connector is on the left side of the PSU.
Installing a Fan Module
1 Remove the fan module from the shipping box.
2 Use the grab handle to slide the module into the switch fan slot.
Install the Hardware 16