Setup Guide
Table Of Contents
- About this Guide
- Install the Hardware
- Install the Chassis
- Rack Mounting Safety Considerations
- Rack Mount the Switch
- Installing the Dell ReadyRails System
- Attaching the Ground Cable (Optional)
- Important Points to Remember
- Installing AC Power Supplies
- Installing a Fan Module
- Installing the SFP+ Optics
- Supply Power and Power Up the System
- After Installing the S3048–ON
- Dell Networking OS
- Technical Specifications
Figure 5. Attaching the Switch Rails
2 After you have installed both switch rails, line them up on the previously
mounted Ready-Rails and slide the switch in until it is flush with front of rack.
About 3 inches before you fully insert your system, the rail locking feature
engages to keep the switch from inadvertently sliding out of the rack and
falling.
NOTE: Do not the use the mounted Ready-Rails as a shelf or a workplace.
Install the Hardware 12