Reference Guide

3 Enable (or bring up) the interface in INTERFACE mode.
no shutdown
4 Disable the default switchport conguration and remove it from an interface or a LAG port in INTERFACE mode.
no switchport
5 Enable the OSPFv3 on an interface in INTERFACE mode.
ipv6 ospfv3 process-id area area-id
• process-id — Enter the OSPFv3 process ID for a specic OSPFv3 process (1 to 65535).
• area-id — Enter the OSPF area ID as an IP address (A.B.C.D) or number (1 to 65535).
Enable OSPFv3
OS10(config)# router ospfv3 100
OS10(config-router-ospfv3-100)# exit
OS10(config)# interface ethernet 1/1/1
OS10(conf-if-eth1/1/1)# no shutdown
OS10(conf-if-eth1/1/1)# no switchport
OS10(conf-if-eth1/1/1)# ipv6 ospfv3 300 area 0.0.0.0
Assign Router ID
You can assign a router ID for the OSPFv3 process. Congure an arbitrary value in the IP address format for each router. Each router ID
must be unique. Use the xed router ID for the active OSPFv3 router process. Changing the router ID brings down the existing OSPFv3
adjacency. The new router ID becomes eective immediately.
• Assign the router ID for the OSPFv3 process in ROUTER-OSPFv3 mode.
router-id ip-address
Assign router ID
OS10(config)# router ospfv3 100
OS10(config-router-ospfv3-100)# router-id 10.10.1.5
View OSPFv3 Status
OS10# show ipv6 ospf
Routing Process ospfv3 100 with ID 10.10.1.5
It is an Area Border Router
Min LSA origination 5000 msec, Min LSA arrival 1000 msec
Min LSA hold time 0 msec, Max LSA wait time 0 msec
Number of area in this router is 2, normal 2 stub 0 nssa
Area (0.0.0.0)
Number of interface in this area is 1
SPF algorithm executed 42 times
Area (0.0.0.1)
Number of interface in this area is 1
SPF algorithm executed 42 times
Congure Stub Areas
The Type 5 LSAs are not ooded into stub areas. The ABR advertises a default route into the stub area to which it is attached. Stub area
routers use the default route to reach external destinations.
1 Enable OSPFv3 routing and enter ROUTER-OSPFv3 mode (1 to 65535).
router ospfv3 instance number
2 Congure an area as a stub area in ROUTER-OSPFv3 mode.
area area-id stub [no-summary]
• area-id — Enter the OSPFv3 area ID as an IP address (A.B.C.D) or number (1 to 65535).
438
Layer 3