Reference Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S3048-ON

241

242

243

244

245

246

247

248

249

250

Q: A-Access (Untagged), T-Tagged

x-Dot1x untagged, X-Dot1x tagged

G-GVRP tagged, M-Vlan-stack, H-VSN tagged

i-Internal untagged, I-Internal tagged, v-VLT untagged, V-VLT tagged

NUM Status Description Q Ports

* 1 up A Eth1/1/2 1/1/3:2 1/1/3:3 1/1/3:4 1/1/4

1/1/5 1/1/6 1/1/7 1/1/8 1/1/9 1/1/10 1/1/11 1/1/12 1/1/13 1/1/14 1/1/15 1/1/16 1/1/17 1/1/18

1/1/19 1/1/20 1/1/21 1/1/22 1/1/23 1/1/24 1/1/25:1 1/1/25:2 1/1/25:3 1/1/25:4 1/1/26 1/1/27

1/1/28 1/1/30 1/1/32

A Po40

200 up T Eth1/1/3:2

T Po40

A Eth1/1/31

320 up T Eth1/1/25:4 1/1/32

T Po40

A Eth1/1/3:1

49 1/1/50 1/1/51 1/1/52 1/1/53 1/1/54

The shutdown command stops L3 (routed) trac only. L2 trac continues to pass through the VLAN. If the VLAN is not a routed VLAN

congured with an IP address, the shutdown command has no eect on VLAN trac.

When you delete a VLAN (no interface vlan vlan-id command), any interfaces assigned to that VLAN are assigned to the

default VLAN as untagged interfaces.

Congure a port-based VLAN, enter INTERFACE-VLAN mode for VLAN related conguration tasks and create a VLAN. Assign interfaces in

L2 mode to the VLAN to enable it.

1 Create a VLAN and enter the VLAN number in INTERFACE mode (1 to 4093).

interface vlan vlan-id

2 Delete a VLAN in CONFIGURATION mode.

no interface vlan vlan-id

Create VLAN

OS10(config)# interface vlan 108

Delete VLAN

OS10(config)# no interface vlan 108

View congured VLANs

OS10(config)# do show interface vlan

Vlan 1 is up, line protocol is up

Address is , Current address is

Interface index is 69208865

Internet address is not set

MTU 1532 bytes

LineSpeed auto

Flowcontrol rx off tx off

ARP type: ARPA, ARP Timeout: 240

Last clearing of "show interface" counters Queueing strategy: fifo Time since last interface

status change:

Vlan 200 is up, line protocol is up