Users Guide

Figure 120. Tagged Frame Format
The tag header contains some key information that Dell Networking OS uses:
• The VLAN protocol identier identies the frame as tagged according to the IEEE 802.1Q specications (2 bytes).
• Tag control information (TCI) includes the VLAN ID (2 bytes total). The VLAN ID can have 4,096 values, but two are reserved.
NOTE: The insertion of the tag header into the Ethernet frame increases the size of the frame to more than the 1,518 bytes as
specied in the IEEE 802.3 standard. Some devices that are not compliant with IEEE 802.3 may not support the larger frame
size.
Information contained in the tag header allows the system to prioritize trac and to forward information to ports associated with a specic
VLAN ID. Tagged interfaces can belong to multiple VLANs, while untagged interfaces can belong only to one VLAN.
Conguration Task List
This section contains the following VLAN conguration tasks.
• Creating a Port-Based VLAN (mandatory)
• Assigning Interfaces to a VLAN (optional)
• Assigning an IP Address to a VLAN (optional)
• Enabling Null VLAN as the Default VLAN
Creating a Port-Based VLAN
To congure a port-based VLAN, create the VLAN and then add physical interfaces or port channel (LAG) interfaces to the VLAN.
NOTE
: The Default VLAN (VLAN 1) is part of the system startup conguration and does not require
conguration.
A VLAN is active only if the VLAN contains interfaces and those interfaces are operationally up. As shown in the following example, VLAN 1
is inactive because it does not contain any interfaces. The other VLANs contain enabled interfaces and are active.
NOTE
: In a VLAN, the shutdown command stops Layer 3 (routed) trac only. Layer 2 trac continues to pass through the
VLAN. If the VLAN is not a routed VLAN (that is, congured with an IP address), the shutdown command has no aect on
VLAN trac.
When you delete a VLAN (using the no interface vlan vlan-id command), any interfaces assigned to that VLAN are assigned to
the Default VLAN as untagged interfaces.
To create a port-based VLAN, use the following command.
• Congure a port-based VLAN (if the VLAN-ID is dierent from the Default VLAN ID) and enter INTERFACE VLAN mode.
CONFIGURATION mode
interface vlan vlan-id
To activate the VLAN, after you create a VLAN, assign interfaces in Layer 2 mode to the VLAN.
Example of Verifying a Port-Based VLAN
To view the congured VLANs, use the show vlan command in EXEC Privilege mode.
Dell#show vlan
Virtual LANs (VLANs)
807