Users Guide

Enabling Timestamp on Syslog Messages
By default, syslog messages do not include a time/date stamp stating when the error or message was created.
To enable timestamp, use the following command.
• Add timestamp to syslog messages.
CONFIGURATION mode
service timestamps [log | debug] [datetime [localtime] [msec] [show-timezone] | uptime]
Specify the following optional parameters:
• You can add the keyword localtime to include the localtime, msec, and show-timezone. If you do not add the keyword
localtime, the time is UTC.
• uptime: To view time since last boot.
If you do not specify a parameter, Dell Networking OS congures uptime.
To view the conguration, use the show running-config logging command in EXEC privilege mode.
To disable time stamping on syslog messages, use the no service timestamps [log | debug] command.
File Transfer Services
With Dell Networking OS, you can congure the system to transfer les over the network using the le transfer protocol (FTP).
One FTP application is copying the system image les over an interface on to the system; however, FTP is not supported on virtual local
area network (VLAN) interfaces.
If you want the FTP or TFTP server to use a VRF table that is attached to an interface, you must congure the FTP or TFTP server to use
a specic routing table. You can use the ip ftp vrf vrf-name or ip tftp vrf vrf-name command to inform the FTP or TFTP
server to use a specic routing table. After you congure this setting, the VRF table is used to look up the destination address. However,
these changes are backward-compatible and do not aect existing behavior; meaning, you can still use the source-interface
command to communicate with a particular interface even if no VRF is congured on that interface.
For more information about FTP, refer to RFC 959, File Transfer Protocol.
NOTE
: To transmit large les, Dell Networking recommends conguring the switch as an FTP
server.
Conguration Task List for File Transfer Services
The conguration tasks for le transfer services are:
• Enable FTP Server (mandatory)
• Congure FTP Server Parameters (optional)
• Congure FTP Client Parameters (optional)
Enabling the FTP Server
To enable the system as an FTP server, use the following command.
To view FTP conguration, use the show running-config ftp command in EXEC privilege mode.
• Enable FTP on the system.
CONFIGURATION mode
Management
71