Users Guide
• news (for USENET news messages)
• sys9 (system use)
• sys10 (system use)
• sys11 (system use)
• sys12 (system use)
• sys13 (system use)
• sys14 (system use)
• syslog (for syslog messages)
• user (for user programs)
• uucp (UNIX to UNIX copy protocol)
Example of the show running-config logging Command
To view nondefault settings, use the show running-config logging command in EXEC mode.
Dell#show running-config logging
!
logging buffered 524288 debugging
service timestamps log datetime msec
service timestamps debug datetime msec
!
logging trap debugging
logging facility user
logging source-interface Loopback 0
logging 10.10.10.4
Dell#
Synchronizing Log Messages
You can congure Dell Networking OS to lter and consolidate the system messages for a specic line by synchronizing the message
output.
Only the messages with a severity at or below the set level appear. This feature works on the terminal and console connections available on
the system.
1 Enter LINE mode.
CONFIGURATION mode
line {console 0 | vty number [end-number] | aux 0}
Congure the following parameters for the virtual terminal lines:
• number: the range is from zero (0) to 8.
• end-number: the range is from 1 to 8.
You can congure multiple virtual terminals at one time by entering a number and an end-number.
2 Congure a level and set the maximum number of messages to print.
LINE mode
logging synchronous [level severity-level | all] [limit]
Congure the following optional parameters:
• level severity-level: the range is from 0 to 7. The default is 2. Use the all keyword to include all messages.
• limit: the range is from 20 to 300. The default is 20.
To view the logging synchronous conguration, use the show config command in LINE mode.
70
Management